Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Spring Replacement Cost in Southlands?
Spring replacement in Southlands typically costs $180 – $340 for a single spring, including the part and the labor to install it. Most doors run two springs, and because they wear at the same rate, a matched pair is nearly always replaced together, which puts a pair at roughly $360 – $680. Those are typical estimated ranges for this market. The written estimate you get after we look at your door sets the final price.
If your door came down hard and won’t lift, the spring is the likely cause, and a trained technician should handle it. High-tension springs and the cables they pull against can cause serious injury when they’re under load. Call (844) 569-7232 for a free estimate. We answer 24/7, and dispatch runs 7am to 7pm, Sunday through Friday.
Key Takeaways
- One spring: typically $180 – $340. A matched pair: about double that.
- Price depends on door weight, spring type, drum condition, and whether cables need replacement.
- Springs are one of the most dangerous garage door parts to touch, so this is a job for a trained professional.
- Estimates are free, and the price is set per job in writing before any work starts.
Spring Replacement Cost Breakdown (2026)
Here’s how the numbers usually shake out for a spring job in Southlands. These are typical estimated ranges for the market, not a fixed quote. What you actually pay is set by the written estimate for your door.
| Line item | Typical estimated range |
|---|---|
| Single torsion or extension spring, replaced | $180 – $340 |
| Matched pair of springs (replaced together) | About double the single-spring range |
| Cable repair (often paired with new springs) | $130 – $250 |
| Track realignment | $120 – $240 |
| Roller replacement | $110 – $220 |
| Panel replacement (if the door dropped or bent) | $250 – $500 |
| Full garage door repair, when more than springs is involved | $150 – $600 |
What pushes the number up or down? A single-spring door is the cheapest job. Double doors run heavier springs and more of them. If the old spring took a cable with it, or the door came down uneven and bent a track or a roller, that gets added to the work. A clean spring swap on a door that’s otherwise sound stays near the low end. A door that’s dropped, jammed, or showing cable fraying lands toward the higher end once the extra hardware is included.
We work on virtually every major brand, so the age and make of your door doesn’t leave us guessing. We service LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor systems, and we source garage door parts directly, so a standard spring replacement doesn’t sit waiting on a third-party order. If you want a full picture of what we handle on a door, the garage door repair Southlands page covers the whole scope.
What Affects Spring Replacement Pricing in Southlands
Two identical-looking doors can carry quite different price tags, and it’s rarely about the spring itself. Here’s what moves the number:
- Door weight and size. A single-car door uses lighter springs than a wide double door. Heavier doors need stronger springs, and sometimes a different spring configuration, which nudges the price up.
- Torsion vs. extension springs. Torsion springs run above the door on a shaft; extension springs run along the sides. Each takes different tools and steps, and the type on your door affects labor time.
- Condition of the cables and drums. Springs and cables wear together. If a cable is frayed or a drum is worn, it usually gets replaced at the same time so the new springs don’t get stressed early. That adds the cable range to the bill.
- Whether the door dropped. When a spring lets go, a heavy door can slam and bend a track, pop a roller, or crack a panel. Each of those is a separate line item, which is why a “spring job” sometimes turns into a fuller repair.
- Spring type and cycle life. Standard springs and higher-cycle springs cost different amounts. Choosing a longer-lasting spring can mean a higher part cost now, but you’re not paying to replace the same spring as often.
- Southlands’ climate and the door’s workload. The Front Range swings between hot summers and cold, dry winters. That wide temperature range works any metal hardware, springs included, and doors that open and close many times a day wear their springs faster. A door that’s cycled hard tends to need springs sooner.
One more thing worth knowing: your garage layout matters. Homes around Southlands Town Center and out toward the newer subdivisions often have taller doors or tighter overhead clearance, and that can change which springs fit and how much room there is to work. It’s a small factor, but it’s the kind of detail a specialist checks before quoting rather than after.
Is It Cheaper to Repair a Spring or Replace the Door?
Repairing the spring is almost always cheaper, by a wide margin. Spring replacement runs $180 – $340 for a single spring, while a new door installation runs $700 – $2,200. Replacing the whole door only makes sense when the panels, frame, or structure are genuinely worn out, not because a spring broke.
Here’s the honest split. If the door itself is sound and only the spring failed, fix the spring. That’s the vast majority of calls. If the door is old, the panels are dented or rotting, and it’s been patched repeatedly, then putting money into springs on a failing door is throwing good money after bad, and a replacement gets considered. We’ll tell you which camp you’re in after we’ve looked at it. If it does turn out you need a new door, spring replacement and installation are both part of what we handle, so you’re not chasing a second contractor.
How Spring Replacement Works (and Why It’s Not a DIY Job)
Spring replacement is a two-part job: releasing the tension safely, then installing the new spring and dialing in the right amount of tension so the door balances properly. That balance is what lets a door lift smoothly and stay put when it’s halfway up. Get the tension wrong and the door is either too heavy to lift or slams shut, and the hardware around it takes the abuse.
We don’t walk homeowners through the steps for a reason. The springs and cables hold a large amount of stored force, and the tools and technique required are not something to improvise. A trained technician knows how to release that energy safely, match the spring to the door’s weight, and check that the cables, drums, and rollers are sound before the door goes back into service. That’s the difference between a door that works for years and one that fails again in a season.
If you want to know what you can safely check yourself, it’s this: look at whether the door is level when it’s down, listen for a bang or snap when it opens, see if the door feels unusually heavy when you lift it by hand with the opener disconnected, and look for a visible gap in a torsion spring or stretched extension springs. Any of those is a sign to stop using the door and have it looked at.
How to Save on Spring Replacement
There’s no magic coupon for a spring job, but a few habits keep the bill closer to the low end of the range:
- Get the estimate in writing before work starts. Free estimates mean you can compare a real number to a real number. Call (844) 569-7232 and we’ll come out, look at the door, and give you a set price.
- Replace the pair, not the survivor. If one spring broke, its twin is on borrowed time. Doing both at once means one labor charge and no repeat visit, which is cheaper than paying for two separate single-spring jobs.
- Keep the door balanced. A door that’s been dragging on a worn roller or a bent track wears its springs harder. Small fixes early keep springs lasting their full life.
- Don’t force a broken door. Running the opener on a door with a snapped spring grinds the motor and can bend hardware, turning a spring job into a bigger repair. Stop using it and call.
- Ask about spring cycle life. A longer-cycle spring costs more up front but lasts longer. If your door is used heavily, it’s often the better value over time.
The single biggest saver is catching it early. A noisy, struggling door is usually telling you the spring or a cable is on its way out, and a repair at that stage is cheaper than a door that’s dropped and taken a track and a panel with it.
When Should You Call for Spring Replacement?
The clearest sign is a loud bang from the garage followed by a door that won’t lift. That’s usually a torsion spring breaking. Other signs: the door feels very heavy when you lift it, it opens a few inches and stops, it comes down fast and hard, or you can see a gap in the spring above the door. Any of these means the door should stay down until a technician looks at it.
Don’t wait on a struggling door. A door that’s hard to lift is putting extra strain on the opener and the rest of the hardware every time it moves. Calling early keeps the job in the spring-replacement range instead of the fuller repair range. Call (844) 569-7232. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. If you call outside dispatch hours, we’ll book you into the next opening.
Why Choose a Garage Door Specialist for Spring Work
Springs are the highest-tension part of any garage door, and they’re all we work on. Garage doors are all we do. That focus is why our technicians have up to 8 years of experience with torsion and extension systems across every major brand, and it’s why we treat spring repair as a core service rather than an add-on squeezed in between other trades.
It also means we carry and supply the parts. When your door needs a specific spring, cable, or roller, we can source garage door components directly instead of waiting on a third-party order, which keeps turnaround short. And because we cover the whole system, from opener electronics to mechanical hardware to a full door replacement, you don’t need a second contractor when a spring job turns out to be more. Springs, openers, panels, tracks: one call covers it all.
Our technicians are experienced, and the local professionals we connect you with are licensed and insured as their state requires. We give you an upfront written price, and that’s the price. No surprise add-ons after the fact.
FAQs – Spring Replacement Cost
How much does it cost to replace a garage door spring in Southlands?
A single spring replacement in Southlands typically runs $180 – $340. Most doors have two springs, and since they wear together, a matched pair usually costs about double that, or roughly $360 – $680. The written estimate after we inspect your door sets the final price. Call (844) 569-7232 for a free quote.
Is it cheaper to replace one spring or both?
Replacing both at once is usually cheaper overall. A single spring is $180 – $340, and a pair is about double that, but doing both in one visit means one labor charge instead of two. If one spring has broken, the other is typically near the end of its life, so replacing just the broken one often leads to a second call soon after. Call (844) 569-7232 to get a pair priced for your door.
Can you come out the same day for a broken spring?
Often yes. We dispatch 7am to 7pm, Sunday through Friday, and same-day service is common for spring failures. We answer 24/7, so if you call outside dispatch hours we’ll book you into the next opening. A free estimate comes first, and the price is set in writing before work starts. Call (844) 569-7232.
Why does a spring replacement cost more than just the part?
The part is only part of it. A single spring job at $180 – $340 covers the spring itself plus the skilled labor to release the tension safely, match the spring to your door’s weight, install it, and check the cables, drums, and rollers around it. That safety work is the bulk of the job, and it’s why springs aren’t a DIY fix. Call (844) 569-7232 for a free estimate.
Does replacing a spring ever lead to other repairs?
Sometimes. If the door dropped when the spring broke, it can bend a track ($120 – $240), pop a roller ($110 – $220), or crack a panel ($250 – $500), and a frayed cable ($130 – $250) often gets replaced at the same time. A clean spring swap stays near the low end. We’ll show you on the estimate exactly what’s needed. Call (844) 569-7232.
Get Your Spring Job Priced
A broken spring doesn’t get cheaper by waiting, and a struggling door only works its hardware harder. Whether your door snapped last night or it’s been dragging for weeks, we’ll come out, look at it, and give you a clear written price. Call (844) 569-7232 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday. Springs are the one part of your door to leave to a trained technician, and that’s exactly the work we do.
Pricing reflects the Southlands market as of 2026. Garage Door Repair Southlands offers free estimates – call (844) 569-7232.
Written by the team at Garage Door Repair Southlands.
What Our Customers Say
"The old chain drive sounded like a freight train through the bedroom above the garage. Went with the belt drive they recommended and now I genuinely cannot hear it open from upstairs."
- Bryce Fletcher"Door installed in about four hours, old one hauled away, and he stayed to program both cars and the wall panel before he left."
- Daniel Brooks"Spring snapped at six in the morning with my car sealed inside and me due at work. Somebody was here by eight thirty and had it fixed that morning. Door's quieter now than it was before it broke."
- Mark Bennett